fleXlab Podium User Guide
There are two parts to this guide, the instructor workflow and the student workflow.
<aside> 💡 Please check these once at the beginning of each class:
[ ] Unlock the podium touch screen and operate it as per the fleXlab user guide steps
[ ] When students give their presentations, switch to Presenter view**.** This is how they must start / stop their presentations.
[ ] Pro-tip: check that the presenter is framed up in the Camera Preview block (show in red in the demo above). If they are not in frame, you can tap ‘Reset Camera’ the camera Angle from the ‘Stream’ tab
[ ] Important, after a presenter ends their presentation and enters a file name, they (or you) must put Panopto into a ready state by clicking this tab (1). This step is critical as Panopto will not record without being in this mode.
In the event of any projection glitches, timeouts, etc... you can quickly (<15 sec) refresh to the podium defaults by tapping the following: